area virtual-link authentication rfc6506
(OSPFv3)
area
{
ip-addr
|
decimal
}
virtual-link
E.F.G.H
authentication rfc6506
no area
{
ip-addr
|
decimal
}
virtual-link
E.F.G.H
authentication
RFC 6506 authentication is disabled by default.
OSPFv3 router configuration mode
OSPFv3 router VRF configuration mode
Use this command to set or reset authentication in accordance with RFC 6506 on the OSPFv3 area virtual link. This may be required for backward compatibility. Although RFC 6506 is superseded by RFC 7166, some vendors continue to support RFC 6506. To ensure interoperability with vendor equipment that supports RFC 6506, use this command in conjunction with the required authentication options.
The
no form of the command removes the RFC 6506 authentication configuration from the OSPFv3
area virtual link.
The following example sets HMAC-SHA-1 authentication, in accordance with RFC 6506, on the OSPFv3 area virtual link. HMACSHA-1 authentication is enabled using key-id "1", key "0 1234567890123456789".
device# configure terminal device(config)# ip router-id 10.1.1.1 device(config)# ipv6 router ospf device(config-ospf6-router)# area 1 virtual-link 20.1.1.1 authentication rfc6506 device(config-ospf6-router)# area 1 virtual-link 20.1.1.1 authentication hmac-sha-1 key-id 1 key 0 1234567890123456789
| Release version | Command history |
|---|---|
| 08.0.70 | This command was introduced. |