all-client

Restricts all remote management access methods expect for a specified host.
Syntax
all-client { ip-address | ipv6 ipv6-address }
no all-client { ip-address | ipv6 ipv6-address }
Command Default

Remote management access is not restricted.

Parameters
ip-address
The IP address of the host you want to allow remote management access.
ipv6ipv6-address
The IPv6 address of the host you want to allow remote management access.
Modes

Global configuration mode

Usage Guidelines

By default, an ICX device does not control remote management access based on the IP address of the managing device. Using the all-client command, you can alloq remote management access to a single IP address for all of the following access methods:

  • Telnet access
  • SSH access
  • Web management access
  • SNMP access

You can specify only one IP address at a time. However, you can enter each command ten times to specify up to ten IP host addresses.

The no form of the command removes the access restriction, if only one IP address has been specified. If multiple IP host addresses have been allowed access, you must unconfigure each one .

Examples

The following example shows how to restrict all remote management access methods to a host with IP address 10.157.22.69. 

device(config)# all-client 10.157.22.69
Parent topic: Commands A and B