area virtual-link authentication key-activation-wait-time (OSPFv3)

Configures the time before an authentication key change is activated for an Open Shortest Path First version 3 (OSPFv3) area virtual link.
Syntax
area { ip-addr | decimal } virtual-link E.F.G.H authentication key-activation-wait-time wait-time
no area { ip-addr | decimal } virtual-link E.F.G.H authentication key-activation-wait-time wait-time
Command Default

The keychain wait time default is 300 seconds.

Parameters
ip-addr
Area address in IP address format.
decimal
Area address in decimal format.
E.F.G.H
ID of the OSPF router at the remote end of the virtual link.
wait-time
Specifies the time before an authentication key change takes place. The wait time can be set from 0 through 14400 seconds.
Modes

OSPFv3 router configuration mode

OSPFv3 router VRF configuration mode

Usage Guidelines

Use this command to set or reset the wait time before an authentication key change takes place on the OSPFv3 area virtual link.

The no form of the command resets the wait time to the default of 300 seconds.

Examples

The following example sets the wait time before an authentication key change to 600 seconds on the OSPFv3 area virtual link. 

device# configure terminal
device(config)# ip router-id 10.1.1.1
device(config)# ipv6 router ospf
device(config-ospf6-router)# area 1 virtual-link 20.1.1.1 authentication key-activation-wait-time 600
History
Release version Command history
08.0.70 This command was introduced.
Parent topic: Commands A and B