show link-monitor status
Helps verify link availability,
performance metrics, ans current state (Up/Down) for monitoring network health.
Modes
Network mode
The show link-monitor
status command displays the following information.
| Output field | Description |
|---|---|
| Link Monitor | Identifies the name of the link being monitored. |
| Status | Reflects if the link monitoring is enabled or not. |
| State | Represents the current operational state. |
| Targets | Lists destination endpoints or IP addresses being monitored. |
| Latency(min/avg/max) | Displays the minimum, average, and maximum round-trip latency values observed during the monitoring period. |
| Jitter(min/avg/max) | Shows the variability in packet delay, indicating the minimum, average, and maximum jitter values. |
| Input Rate | The rate of incoming data on the monitored link. |
| Output Rate | The rate of outgoing data on the monitored link. |
Examples
Displays the operational status, target IP, latency, jitter, and traffic statistics of configured link monitor interfaces such as port1 and port2.
DBGvpp# show link-monitor status =========================================================== Link Monitor: port1, Status: Enabled, State: Up Targets: 8.8.8.8 (icmp) Latency(min/avg/max): (0.00/0.00/0.00) ms Jitter(min/avg/max): (0.00/0.00/0.00) ms Input Rate: 0.00 bits/sec Output Rate: 0.00 bits/sec =========================================================== Link Monitor: port2, Status: Enabled, State: Up Targets: 8.8.8.8 (icmp) Latency(min/avg/max): (0.00/0.00/0.00) ms Jitter(min/avg/max): (0.00/0.00/0.00) ms Input Rate: 0.00 bits/sec Output Rate: 0.00 bits/sec
History
| Release version | Command history |
|---|---|
| 2.4.0 | This command was introduced. |