Configuring Cluster Interface Settings

The cluster interface is used as a communication channel between the RUCKUS Edge devices.
This section describes configuring Cluster Interface Settings.

After configuring the LAG, Port and Virtual IP Settings and clicking Apply & Continue (as described in Configuring RUCKUS Edge Cluster Ports and IP Settings), select the Cluster Interface Settings checkbox and click Next. This displays the Cluster Interface page containing a tab for each Edge device in the cluster.

  1. On the first device tab, configure these settings:
    • Set cluster interface on: Use the drop-down menu to select the port that you want to serve as the cluster interface to the other Edge device.
    • IP Assignment: Select DHCP or Static/Manual. If you select Static/Manual, then enter the IP Address and Subnet Mask address of cluster interface port.
  2. Repeat on the second device tab.
  3. Review the configuration and click one of the following:
    • Apply & Continue to apply the Change Cluster Interface configuration.
    • Apply & Finish to complete the Change Cluster Interface configuration.