Configuring Inline Power on PoE Ports in a LAG

Complete the following steps to configure and deploy a link aggregation group (LAG) on the required PoE ports on both the power-sourcing equipment (PSE) and the PD. This configuration also enables inline power on the PoE ports.

  1. Configure a LAG. 
    device(config)# lag "mylag" static id 5
    This command configures a static LAG named mylag with an ID of 5.
  2. Configure ports into the LAG membership. 
    device(config-lag-mylag)# ports ethernet 1/1/1 to 1/1/4
    This command enters the four ports, 1/1/1, 1/1/2, 1/1/3, and 1/1/4, into LAG membership.
  3. Configure inline power on a member port of the LAG with the power-by-class option. 
    device(config)# inline power ethernet 1/1/1 power-by-class 3
  4. Configure inline power on a member port with the default option. 
    device(config)# inline power ethernet 1/1/2
    This command configures inline power on port 1/1/2 with the default option.
  5. Configure inline power on a member port with the power management option. 
    device(config)# inline power ethernet 1/1/3 priority 2
    This command configures inline power on port 1/1/3 with power management option 2.
  6. Configure inline power on a member port, specifying the actual power value. 
    device(config)# inline power ethernet 1/1/4 power-limit 12000
    This command configures inline power on port 1/1/4, specifying a power value of 12,000 mW.
Parent topic: Inline Power on PoE LAG Ports