Converting Stacking Ports to Data Ports on ICX 7150 Devices

Follow these steps to convert a stacking port to a data port on an ICX 7150 device.

Enter global configuration mode.
```
ICX7150-24 Router# configure terminal
```

Enter configuration mode for the stack unit.
```
ICX7150-24 Router(config)# stack unit 1
ICX7150-24 Router(config-unit-1)# 
```
The example enters configuration mode on stack unit 1.

Use the no stack-port command to remove stacking from one stacking port to convert it to a data port.

Note: Starting from FastIron release 09.0.00, converting a live stacking port to a data port using the multi-stack-port or the multi-stack-trunk command disables the resulting data ports to avoid potential loops. However, this feature does not apply to the stack-port or the stack-trunk command.
```
ICX7150-24 Router(config-unit-1)# no stack-port ethernet 1/3/3
stack-port ethernet 1/3/3 is removed.
```

The following example converts stacking port 1/3/3 to a data port.

ICX7150-24 Router# configure terminal
ICX7150-24 Router(config)# stack unit 1
ICX7150-24 Router(config-unit-1)# no stack-port ethernet 1/3/3
stack-port ethernet 1/3/3 is removed.

ICX7150-24 Router(config-unit-1)# show stack
T=41m15.7: alone: standalone, D: dynamic cfg, S: static
ID   Type          Role    Mac Address    Pri State   Comment                   
1  S ICX7150-24    active  00e0.5200.0100 128 local   Ready
2  S ICX7150-48P   standby 748e.f882.e418   0 remote  Ready

    standby      active                                                        
     +---+        +---+                                                        
  3/3| 2 |3/1==3/1| 1 |                                                        
     +---+        +---+                                                        
Will assign standby in 58 sec due to all ready

Standby u2 - protocols ready, can failover
Current stack management MAC is 00e0.5200.0100

Stacking by Device

Converting Stacking Ports to Data Ports on ICX 7150 Devices