VRRPv3

In this section:

  1. VRRPv3 Overview
    VRRP version 3 (VRRPv3) introduces IPv6 address support for both standard VRRP and VRRP enhanced (VRRP-E).
  2. Enabling an IPv6 VRRPv3 owner device
  3. Enabling an IPv6 VRRPv3 Backup Device
  4. Enabling an IPv4 VRRPv3 Owner Device
  5. Enabling an IPv4 VRRPv3 Backup Device
  6. Tracked ports and track priority with VRRP and VRRP-E
    Port tracking allows interfaces not configured for VRRP or VRRP-E to be monitored for link-state changes that can result in dynamic changes to the VRRP device priority.
  7. Accept mode for backup VRRP devices
    Accept mode allows a backup VRRP device to respond to ping, traceroute, and Telnet packets if the backup device becomes the master VRRP device.
  8. Alternate VRRPv2 checksum for VRRPv3 IPv4 sessions
    If VRRPv3 is configured on a RUCKUS device in a network with third-party peering devices using VRRPv2-style checksum calculations for IPv4 VRRPv3 sessions, a VRRPv2-style checksum must be configured for VRRPv3 IPv4 sessions on the RUCKUS device.
  9. Automatic Generation of a Virtual Link-local Address for VRRPv3
    The virtual MAC address is used to automatically generate the IPv6 virtual link-local address to simplify the configuration of IPv6 VRRP and standardize implementations across vendor platforms. Subsequent VRRPv3 advertisements carry the auto-generated virtual link-local address.
  10. Displaying VRRPv3 Statistics
    Various show commands can display statistical information about IPv6 VRRP configurations.
  11. Clearing VRRPv3 statistics
    VRRPv3 session counters can be cleared using a CLI command.
  12. VRRP-Ev3 Overview
    VRRP Extended version 3 (VRRP-Ev3) introduces IPv6 address support to the RUCKUS proprietary VRRP Extended version 2 (VRRP-Ev2) protocol. VRRP-Ev3 is designed to avoid the limitations in the standards-based VRRPv3 protocol.
  13. VRRP-E Load-Balancing Using Short-Path Forwarding
  14. Enabling an IPv6 VRRP-Ev3 Device
  15. Displaying and Clearing VRRP-Ev3 Statistics
    Several show commands can display statistical information about IPv6 VRRP-Ev3 configurations. To reset the IPv6 VRRP-Ev3 statistics, there is a CLI command.