Displaying OSPFv3 Results

To view the OSPFv3 interface details and authentication settings, use the show ipv6 ospf interface command. This command is optional and allows you to verify the OSPFv3 details.
  1. Enter the show ipv6 ospf interface command to display general OSPFv3 information. 
    device# show ipv6 ospf interface 
 
ve 500  admin up, oper up, IPv6 enabled
  IPv6 Address:
      fe80::1
  Instance ID 0, Router ID 71.50.71.50
  Area ID 1, Cost 1, Type BROADCAST
  MTU: 1500
  State BDR, Transmit Delay 1 sec, Priority 1, Link-LSA Tx not suppressed
  Timer intervals :
    Hello 10, Hello Jitter 10  Dead 40, Retransmit 5
  IPSec Authentication: Enabled
   KeyRolloverTime(sec): Configured: 300 Current: 0
   KeyRolloverState: NotActive
   Outbound: None
   Inbound: None
  Authentication-trailer: Configured
   In-Use: hmac-sha-256, Key: ********, Key-id: 1
   Higher 32-bitSequence Number 4(0x4), Lower 32-bitSequence Number 133(0x85)
  DR:50.1.1.1 BDR:71.50.71.50  Number of I/F scoped LSAs is 2
  DRElection:     1 times, DelayedLSAck:     1 times
  Neighbor Count = 1,   Adjacent Neighbor Count= 1
     Neighbor:
      50.1.1.1 (DR)
    Statistics of interface ve 500 :                              
      Type     tx         rx         tx-byte    rx-byte   
      Unknown  0          0          0          0         
      Hello    117        122        4668       4880      
      DbDesc   2          5          116        240       
      LSReq    6          0          456        0         
      LSUpdate 5          8          432        1552      
      LSAck    3          2          148        192       
      OSPF messages dropped:
          Authentication Failure(IPSec)       : 0
          Authentication Failure(Auth-Trailer): 2
Parent topic: OSPFv3 Authentication Trailer Configuration