show breakout
Displays information on 10 Gbps sub-ports
broken out from 40 Gbps ports on certain FastIron devices, and provides details
on the
breakout configuration and operational status of the sub-ports.
Modes
Privileged EXEC mode
Usage Guidelines
The show breakout command is
available only on certain and ICX 7850 40-Gbps ports and
100-Gbps ports. Refer to the
FastIron Management Configuration Guide for a table of available breakout
ports. Refer to the RUCKUS
ICX 7550 Switch Hardware Installation Guide and RUCKUS ICX 7850 Ethernet
Switch Hardware Installation Guide for detailed information on breakout
cables. The
show breakout command displays the following information:
| Output field | Description |
|---|---|
| Port | Specifies the port for which breakout information is displayed to the right. |
| Module Exist | Indicates whether the module on which the specified port resides is present in the unit. |
| Module Conf | Indicates whether the module on which the specified port resides is configured. |
| Breakout-config | Indicates whether breakout is configured on the specified port. |
| Breakout-oper | Indicates whether sub-ports on the specified breakout port are operational. |
Examples
The following example displays breakout port information for an ICX 7550-24F device with the slot 2 uplink-100G setting.
device> show breakout Unit-Id: 1 Port Module Exist Module Conf breakout_conf breakout_oper 1/2/2 Yes No Yes Yes
The following example displays breakout port information for an ICX 7850-48FS device.
device> show breakout Unit-Id: 1 Port Module Exist Module Conf breakout_conf breakout_oper 1/2/1 Yes No Yes Yes 1/2/2 Yes No No No 1/2/3 Yes No Yes Yes 1/2/4 Yes No No No 1/2/5 Yes No No No 1/2/6 Yes No No No 1/2/7 Yes No No No 1/2/8 Yes No No No
History
| Release version | Command history |
|---|---|
| 08.0.30 | This command was introduced. |