AP State Change Events

Following are the events related to access point state changes:

Event

Event

Event

AP rebooted by user

AP rebooted by system

AP disconnected

AP IP address updated

AP reset to factory default

AP channel updated

AP country code updated

AP channel updated because dynamic frequency selection (DFS) detected a radar

AP change control plane

AP connected

AP deleted

AP heartbeat lost

AP tagged as critical

AP cable modem interface down

AP brownout

AP cable modem power-cycled by user

AP smart monitor turn off WLAN

AP client load balancing limit reached

AP client load balancing limit recovered

AP WLAN state changed

AP capacity reached

AP capacity recovered

AP cable modem interface up

AP cable modem soft-rebooted by user

AP cable modem set to factory default by user

AP health high latency flag

AP health low capacity flag

AP health high connection failure flag

AP health high client count flag

AP health high latency clear

AP health low capacity clear

AP health high connection failure clear

AP health high client count clear

Primary DHCP AP is down

Primary DHCP AP is up

Secondary DHCP AP is down

Secondary DHCP AP is up

Primary or secondary DHCP AP detects 90% of the configured total IPs

Both primary and secondary DHCP server APs are down

AP NAT gateway IP failover detected for particular VLAN pool

AP NAT gateway IP fall back detected for particular VLAN pool

NAT VLAN capacity affected detected by NAT gateway AP at zone due to three (3) consecutive NAT gateway AP IPs are down for particular VLAN pool

NAT VLAN capacity restored detected by NAT gateway AP due to (at least) one out of the three (3) consecutive NAT gateway AP IP were down is now up

AP NAT failure detected by SZ due to three (3) consecutive NAT gateway APs are down

AP health high airtime utilization flag

AP health high airtime utilization clear

AP cluster failover

AP cluster rehome

 

AP MAC OUI violation

Backhaul switched to primary

Backhaul switched to secondary

LTE network connectivity lost

Ethernet network connectivity lost

LTE DHCP timeout

Ethernet link down

Ethernet link up

SIM switch

Remote host blacklisted

SIM removal

LTE network reg status

LTE connection status

AP System Anomaly

AP Preamble Puncturing Pattern Updated

AP Recovery Factory Reset

AP on Recovery Partition

AP on Recovery Partition After Panic