Support for Multicast Multi-VRF
PIM sparse mode (PIM-SM) and PIM dense mode (PIM-DM) are supported by the Multicast Multi-VRF feature on RUCKUS devices.
- The procedure for configuring PIM within a VRF instance is described in the “Enabling PIM on the device and an interface” and the “Configuring global PIM Sparse parameters” sections.
Changes to system-max Commands
Several changes have been made to the
system-max commands in support of Multicast Multi-VRF. The
system-max pim-mcache command has been deprecated and replaced by the
system max pim-hw-mcache command.
The following new runtime commands have been introduced:
max-mcache: The maximum number of repeated cache entries for PIM traffic being sent from the same source address and being received by the same destination address. To define this maximum for the default VRF, configure themax-mcachecommand in router PIM configuration mode; to define the maximum for a specific VRF, first configure therouter pim vrfcommand.ip igmp max-group-address: Configures the maximum number of IGMP addresses for the default virtual routing and forwarding (VRF) instance or for a specified VRF. Theip igmp max-group-addresscommand replaces thesystem-max igmp-max-group-addresscommand.
Support for show and clear Commands
The following show and
clear commands have been updated to support the Multicast
Multi-VRF feature:
clear ip igmp[ vrf vrf-name ] cacheclear ip igmp[ vrf vrf-name ] trafficshow ip igmp[ vrf vrf-name ] groupshow ip igmp[ vrf vrf-name ] interfaceshow ip igmp[ vrf vrf-name ] settings-
show ip igmp[ vrf vrf-name ] traffic
For full syntax details, refer to the RUCKUS FastIron Command Reference.