Limitations
The following limitations must be
noted:
- Client Devices: In Standard Power mode, the maximum transmit power allowed for client devices in a wireless network with a 160 MHz bandwidth is 21 dBm. However, for client devices operating in a wider bandwidth, like 320 MHz, the maximum transmit power limit is higher, at 24 dBm. Furthermore, a client device in the 6 GHz band, whether in LPI or SP mode, is always limited to a transmit power 6 dBm below that of the AP with which it is associated. These regulatory limits are set to minimize interference.
- Outdoor Access Points and Fixed Client Devices: The maximum equivalent isotropic radiated power (EIRP) at any elevation angle above 30 degrees (as measured from the horizon) for outdoor APs and fixed client devices is 21 dBm (125 mW), regardless of bandwidth.
- Indoor Access Points: Low Power Indoor (LPI) mode limits indoor APs to a maximum equivalent isotropic radiated power (EIRP) of 30 dBm and a maximum power spectral density (PSD) of 5 dBm/MHz.
- Enforcement of 30° Antenna Separation: Outdoor APs and Fixed Client devices must be mounted such that they maintain a minimum 30° angular separation to minimize interference. This separation angle helps reduce co-channel interference and ensures better performance.
- Low Power Indoor (LPI): Indoor APs in LPI mode are limited to a maximum equivalent isotropic radiated power (EIRP) of 30 dBm and a maximum power spectral density (PSD) of 5 dBm/MHz.
- Standalone AP with solo image: AFC Proxy Server and Geolocation Service Server are not accessible for standalone AP with solo image.