Reconfiguring ICX 7250 1-Gbps Ports as 10-Gbps Ports
A port previously configured as a 1-Gbps port must be reconfigured to operate at
10 Gbps. Stacking on the ICX 7250 is only available on 10-Gbps ports in module 2.
Note: A license is required for 10-Gbps ports on the ICX 7250. Refer to the
RUCKUS FastIron Software Licensing Guide for additional information.
Note: Once a 10-Gbps port license is installed, previously unconfigured ports that are covered
by the license come up automatically as 10-Gbps ports. Ports must then be configured
for stacking. Refer to
ICX 7250 stacking configuration notes.
Use the
speed-duplex command to reconfigure port speed on a 1-Gbps port.