Configuring 10-Gbps Stacking Ports on ICX 7450 Devices
By default, the ICX 7450 uses 40-Gbps ports in slots 3 and 4 as stacking ports. When
a 4X10GF module is installed in slot 2 on the front panel of an ICX 7450, 10-Gbps
stacking can be configured.
Note: Stacking and MACsec cannot be configured on these 10-Gbps ports at the same time.
Refer to
Converting ICX 7450 slot 2 ports for MACsec or stacking for more information.
To configure stacking on 10-Gbps ports in a 4X10GF module installed in slot 2, configure
use the
stack-port or
stack-trunk command to configure stacking ports or trunks as shown in the following example.
ICX7450-48P Router# show stack ***** Warning! stack is not enabled. ***** T=1h27m15.0: alone: standalone, D: dynamic cfg, S: static ID Type Role Mac Address Pri State Comment 1 S ICX7450-48P alone 609c.9f2a.97e0 0 local None:0 +---+ 3/1| 1 |4/1 +---+ Current stack management MAC is 609c.9f2a.97e0 ICX7450-48P Router# configure terminal ICX7450-48P Router(config)# stack unit 1 ICX7450-48P Router(config-unit-1)# stack-port 1/2/1 stack-port 1/2/1 replaces stack-port 1/3/1 and stack-port 1/4/1 <-- Previous stacking configuration for other modules is replaced. T=1h12m9.8: Module 2 was inited with MACSEC. Its ports cannot be stack-ports without a reload. Reload required. Please write memory and then reload or power cycle. ICX7450-48P Router(config-unit-1)#stack-port 1/2/3 T=1h12m16.2: Module 2 was inited with MACSEC. Its ports cannot be stack-ports without a reload. Reload required. Please write memory and then reload or power cycle. ICX7450-48P Router(config-unit-1)# show running-config Current configuration: ! ver 08.0.90 ! stack unit 1 module 1 icx7450-48p-poe-management-module module 2 icx7400-xgf-4port-40g-module module 3 icx7400-qsfp-1port-40g-module module 4 icx7400-qsfp-1port-40g-module stack-port 1/2/1 stack-port 1/2/3 ! ICX7450-48P Router(config)# write memory | ! | <-- Required if stack-port or stack-trunk ICX7450-48P Router(config)# end | configuration changes on prospective ICX7450-48P Router# reload | active controller !
Once the stack-ports are configured, enter the
write memory and then the
reload command, after which the unit is ready to join an existing stack or to be configured
for stacking using stack interactive-setup or manual stack construction.
Note: You must enable stacking with the
stack enable command before you can initiate stack interactive-setup or construct a stack.
Note: Changing the
stack-port configuration and entering the
reload command are not required for a unit to be discovered by stack interactive-setup or
stack zero-touch provisioning. However, you must reload the prospective active controller
after its stacking ports are changed before you initiate stack interactive-setup or
stack zero-touch provisioning from that unit. The units to be discovered do not need
to configure anything or reload. The active controller reloads them as members after
they are discovered.
Note: If you use the manual construction method, you must reload every unit if you have
changed stacking ports 1/3/1 and 1/4/1 to ports on slot 2.