cluster-redundancy

Creates or updates a cluster redundancy configuration.
Syntax
cluster-redundancy

After the cluster redundancy command is entered to enable the Cluster Redundancy configuration mode, the following configuration syntax is available:

[get-ap-keep-connected-timeout|get-mode|set-ap-keep-connected-timeouttimeout|set-mode{backupname|monitor}]
Command Default

A cluster redundancy configuration is not created or updated.

Parameters
get-ap-keep-connected-timeout
Gets the AP keep connected timeout.
get-mode
Gets the redundancy mode of the standby cluster.
set-ap-keep-connected-timeouttimeout
Sets the AP keep connected timeout in minutes. Valid values range from 10 through 720 minutes.
Modes

Global configuration mode

Usage Guidelines

The get-mode command gets the redundancy mode of the standby cluster. In monitor mode it indicates that the standby cluster does NOT serve any Active cluster and in backup mode it indicates that the standby cluster serves as an Active cluster. This command is supported only on the vSZ-H controllers.

Examples

The following example enters Cluster Redundancy configuration mode. 

device# cluster-redundancy
device(config-cluster-redundancy)
History
Release version Command history
5.1 get-mode was added.
Parent topic: Commands A through C