ap-model

Specifies the AP model to be used.
Syntax
ap-modelap-model-name

After the ap-model command has been entered to enter AP Model configuration mode, the following configuration syntax is available (syntax in groupings for clarity):

[ext-ant{2.4gnum|2.4ggnum[2|3]|5gnum|5ggnum[2|3]]
[internal-heater|lan|led|led-mode|lldp|lldp-ad-intervalseconds|lldp-hold-timeseconds|lldp-mgmt|poe-operating-modepoe-value|poe-out-port|radio-bandradio-value|]
[{usb | usb-software}ap-model[enable|disable]
Command Default

No AP model is specified.

Parameters
ap-model-name
Specifies the AP model name.
ext-ant
Specifies the external antenna wireless frequency.
2.4gnum
Enables the external 2.4 GHz antenna on the selected AP model and sets the gain number as a number between 0 and 90dBi.
2.4ggnum23
Enables the external 2.4 GHz antenna on the selected AP model, sets the gain number, and .
5gnum
Enables the external 5 GHz antenna on the selected AP model and sets the gain number as a number between 0 and 90dBi.
5ggnum23
Enables the external 5 GHz antenna on the selected AP model, sets the gain number, and sets the.
internal-heater
Enables the heater that is built into the AP model.
led
Specifies Hotspot 2.0 as the authentication method.
led-mode
Specifies Hotspot 2.0 Secure Onboarding (OSEN) as the authentication method.
web-authentication
Specifies Web authentication as the authentication method.
Modes

IPSec Profile configuration mode

WLAN Zone configuration mode

Usage Guidelines

This command is available only after one of the following commands is entered:

  • ipsec-profile

  • wlan

Examples

The following example creates a WLAN in zone Zone10, and sets the authentication type yo be guest access. 

device# config
device(config)# zone zone10
device(config-zone)# wlan wlan20
device(config-zone-wlan)# auth-type guest-access
Parent topic: Commands A through C