Flush-Rear (Recessed) Mounting the Device in the Rack

The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.

Caution: The device must be turned off and disconnected from the network during this procedure.
Note: Illustrations used in these rack installation procedures are for reference only and may not show the actual device that you are installing.

Complete the following tasks to install the device in a four-post rack:

  1. Attaching the front brackets to the rear of the device
  2. Attaching the extensions to the front of the device
  3. Installing the device in the rack
  4. Attaching the rear brackets to the extensions at the front of the device
  5. Attaching the rear brackets to the front rack posts

In this section:

  1. Front Brackets to the Rear of the Device
  2. Attaching the Bracket Extensions to the Front of the Device
  3. Installing the Device in the Rack
  4. Attaching the Rear Brackets to the Bracket Extensions at the Front of the Device
  5. Attaching the Rear Brackets to the Front Rack Posts
Parent topic: Installing the 1U, 1.5U, and 2U Universal Kit for Four-Post Racks (XBR-R000295)