Setting Module 2 to 100G Uplink mode

Breakout is supported only on module 2 in all ICX 7550 models. Use the slot 2 uplink-100g command to set the module 2 to 100G uplink mode on ICX 7550-24ZP, ICX 7550-48ZP, ICX 7550-24F, and ICX 7550-48F models.

Note: The

slot 2
                     uplink-100g

command is not allowed if slot 3 has ICX 7600-2X40GQ 2-port 80G module present or configured. Also, if slot 3 is in operational slot profile mode, then slot 3 cannot configure or turn on ICX7600-2X40GQ 2-port 80G module after insertion.

Enter the global configuration mode.
```
ICX7550-48F Router# configure terminal
```

Enter the following command to configure the module 2.

ICX7550-48F Router(config)# slot 2 uplink-100g

Changes require reload to take effect. Please do write memory and then reload or power cycle!!!
Slot 2 will be operating in uplink mode with 100Gbps speed after reload

ICX7550-48F Router(config)# exit
ICX7550-48F Router# write memory
ICX7550-48F Router# reload

Enter the show running-config command to display the running configuration.

ICX7550-48F Router# show running-config
Current configuration:
ver 08.0.95devT243
stack unit 1
module 1 icx7550-48f-port-management-module
module 2 icx7550-100g-2port-200g-module
stack mac 54ec.2f24.f8b6
slot 2 uplink-100g

The following example shows how to go back to default mode.

ICX7550-48F Router(config)# no slot 2 uplink-100g
Changes require reload to take effect. Please do write memory and then reload or power cycle!!!
Slot 2 will be operating in default mode after reload.

Configuration Fundamentals

Setting Module 2 to 100G Uplink mode