Displaying management VRF information

To display IP Information for a specified VRF, enter the show vrf command and specify the VRF for which you want to display IP information.

device(config)# show vrf mvrf

VRF mvrf, default RD 1100:1100, Table ID 11
Configured as management-vrf
IP Router-Id: 1.0.0.1
  Interfaces:
    ve3300 ve3400
  Address Family IPv4
    Max Routes: 641
    Number of Unicast Routes: 2
  Address Family IPv6
    Max Routes: 64
    Number of Unicast Routes: 2

The show who command displays information about the management VRF from which the Telnet or SSH connection has been established.

device(config)# show who

Console connections:
        established, monitor enabled, privilege super-user, in config mode
        1 minutes 47 seconds in idle
Telnet server status: Enabled
Telnet connections (inbound):
 1      established, client ip address 10.53.1.181, user is lab, privilege super-user
        using vrf default-vrf.
        2 minutes 46 seconds in idle
 2      established, client ip address 10.20.20.2, user is lab, privilege super-user
        using vrf mvrf.
        16 seconds in idle
 3      closed
 4      closed
 5      closed
Telnet connections (outbound):
 6      established, server ip address 10.20.20.2, from Telnet session 2, , privilege super-user
        using vrf mvrf.
        12 seconds in idle
 7      closed
 8      closed
 9      closed                                                    
 10     closed
SSH server status: Enabled
SSH connections:
 1      established, client ip address 10.53.1.181, privilege super-user
        using vrf default-vrf.
        you are connecting to this session
        3 seconds in idle
 2      established, client ip address 10.20.20.2, privilege super-user
        using vrf mvrf.
        48 seconds in idle
 3      closed
 4      closed
 5      closed
 6      closed
 7      closed
 8      closed
 9      closed
 10     closed
 11     closed
 12     closed
 13     closed
 14     closed
 15     closed
 16     closed

To display packet and session rejection statistics due to failure in management VRF validation, enter the show management-vrf command.

device(config)# show management-vrf

 Management VRF name : sflow
 Management Application       Rx Drop Pkts      Tx Drop Pkts
  SNMP Engine                            0                11
  RADIUS Client                          0                 0
  TFTP Client                            0                 0
  Traps                                  -                 0
  SysLogs                                -                 0

 TCP Connection rejects:                
  Telnet            :          0
  SSH       (Strict):        685
  TACACS+ Client    :          0

Ensure that the management VRF is configured before executing the show management-vrf command. If not, the system displays the following error message.

Error - Management VRF is not configured.

To clear the management VRF rejection statistics, enter the following command.

device(config)# clear management-vrf-stats