Setting Module 2 to 40G Uplink Mode

The following task sets module 2 to uplink-40-Gbps mode on ICX 7550 devices with a 2x100G module installed in slot 2, using the slot 2 uplink-40g command. The uplink-40-Gbps mode is supported only if 2x40-Gbps is present in module 3 or if module 3 is empty. Ports without the slot 2 uplink-40g or slot 2 uplink-100g configurations use module 2 as the default stacking port.

Note: For ICX 7550-24ZP, ICX 7550-24F, and ICX 7550-24XZP devices, the uplink-40-Gbps mode supports only 2x40-Gbps in module 3 and an error message is displayed if an unsupported module is present in module 3.
Note: For ICX 7550-48ZP and ICX 7550-48F devices, the uplink-40-Gbps mode is supported only if module 3 contains a 2x40-Gbps configuration or if module 3 is empty.
  1. Enter global configuration mode.
    device# configure terminal
  2. Enter the slot 2 uplink-40g command to configure module 2.
    device(config)# slot 2 uplink-40g

Changes require reload to take effect. Please do write memory and then reload or power cycle!!!
Slot 2 will be operating in uplink mode with 40Gbps speed after reload

    device(config)# exit
device# write memory
device# reload
  3. Enter the show running-config command to display the running configuration.
    device# show running-config
Current configuration:
ver 10.0.20_b108T243
stack unit 1
module 1 icx7550-24f-port-management-module
module 2 icx7550-100g-2port-200g-module
module 3 icx7600-xgf-4port-40g-module
stack-port ethernet 1/2/1
stack-port ethernet 1/2/2
stack rconsole-off
slot 2 uplink-40g
Parent topic: Breakout