Timeout

Why does a Timeout No Response occur during a full SNMP MIB walk?
Added in 3.6
  1. Scenario 1 : When querying full MIBs

    Following are the solutions to resolve the timeout issue.

    1. Increase the timeout value of the SNMP client tools. Always try to increase the timeout value of the SNMP MIB browser or SNMP CLI commands based on the number of APs and UEs on the controller (SmartZone).
    2. Do a snmpwalk for a specified table. Otherwise, it is likely that SNMP will focus on the standard table tcpConnTable, which collects all the TCP connections of the controller. The table size could be large based on the large number of APs or UEs associated to a controller .
  2. Scenario 2 : When querying AP related table for controllers with large number of APs and UEs

    Following are the solutions to resolve the timeout issue.

    1. Increase the interval of the query scripts or tools to make sure there is only one SNMP client tool to query the controller at a time. Adjust the query interval of the query scripts or tools by the loading of the controller. Otherwise, SNMP daemon takes longer to complete all queries. It is recommended that you do not run multiple queries at the same time.
    2. Do not use MIB browser to monitor the APs. Most MIB browsers can only provide snmpwalk which is not an efficient for querying large volume of data and are unable to store large volumes of data.
    3. Increase the timeout value of the SNMP client tools. Always try to increase the timeout value of the SNMP MIB browser or SNMP CLI commands based on the number of APs and UEs on the controller.
    4. Get the table index by using snmpwalk and use snmpget to get multiple entries of same index at a time.
      1. Step 1 - Use a script to query the index of the table using snmpwalk as seen in the below example.
        Example:
        snmpwalk <options> <IP>  <table index 1 OID>snmpwalk <options> <IP>  <table index 2 OID>
      2. Step 2 - Use a script to query multiple table entries for same index at a time using snmpget as seen in the below example.
        Example:
        snmpget <options> <IP>  <table entry 1 OID>.index1 <table entry 2 OID>.index1 ... 
        <table entry N OID>.index1