Determining the Query Interval for AP Related Tables

How to determine the query interval for AP related tables ?
Changes as per 3.6.1

Use snmpwalk to get an OID of the AP related table to determine the time to complete the snmpwalk for a single OID.

  1. Scenario 1 : Using simple snmpwalk

    If you are unable to write your own script as suggested in Timeout the approximate time for an OID may be between the range of 1 to 4 minutes per seconds. This is based on lab environments tested in Ruckus.

    The efficiency is improved in 3.6.1 as:

    a: For 1,000 APs the minimum time is 54 seconds (< 1 minute) for a full table

    b: For 10,000 APs the minimum time is 203 seconds (< 2 minutes) for a full table.

    For example, in an environment with 10,000 APs and 1000 WLANs, the values are:

    MIB Table SNMPWalk Elapsed Time Comment
    RUCKUS-SCG-WLAN-MIB::ruckusWLANTable 41 seconds
    RUCKUS-SCG-WLAN-MIB::ruckusSCGWLANTable 42 seconds
    RUCKUS-SCG-WLAN-MIB::ruckusWLANAPTable 203 seconds
    RUCKUS-SCG-WLAN-MIB::ruckusSCGAPTable 107 seconds
    RUCKUS-SCG-CONFIG-WLAN-MIB::ruckusSCGConfigWLANTable 50 seconds Timeout should be set as 25+ seconds.
    Note: The exact value should be tested in your own environments.