Setting Up the Controller for the First Time

RUCKUS SmartZone controllers are next-generation high-performance wireless LAN controllers that run the RUCKUS SmartZone operating system. To deploy the controller, it must first be set up on the network. For information on how to set up the controller for the first time, including instructions for preparing your chosen hypervisor, installing the vSZ image on to hypervisor, and completing the vSZ Setup Wizard, refer to the Getting Started Guide or Quick Setup Guide for your controller platform.

Note: While deploying vSZ, block level storage must be used and the hosts must see this as direct-attached storage. For real time database access and synchronization, vSZ requires lower latency and higher numbers of read/write transactions than file level storage solutions such as NAS or network file shares allow.

3.6.1 Update
SZ 5.1 Update - reused across platforms - changed vCenter version from 6.5 to 6.7 on ESXi
You can deploy vSZ and vSZ-D via vCenter 6.7 on ESXi. Some of the features (for example, location based services, rogue AP detection, force DHCP, and others) may not be visible on the controller web interface if the AP firmware deployed to the zone you are configuring is earlier than this release. To ensure that you can view and configure all new features that are available in this release, RUCKUS recommends upgrading the AP firmware to the latest version.