OS Prompt Recovery Procedures
no password
command is no longer supported at the uboot prompt. Refer to "Password and Device
Recovery" in the RUCKUS FastIron Management
Configuration Guide for information on password recovery.If during an upgrade procedure, the ICX device
enters the OS mode and does not exit, use the copy tftp flash command at
the OS prompt to re-install the image.
The following example downloads the FastIron 09.0.10a UFI from the TFTP server at the specified IP address to primary flash memory in the ICX device.
OS> copy tftp flash 192.168.10.89 SPR9010aufi.bin primary
To configure the IP address, subnet mask, and
default gateway for an ICX device in OS mode, use the remote_address
and remote_gateway commands, as shown in the following
example.
OS> remote_address 10.176.132.159 255.255.255.128 OS> remote_gateway 10.176.132.129
To copy the FastIron image from the remote TFTP
server to the ICX device at the OS prompt, use the copy tftp flash
command followed by the IP address of the server, the correct image name, and the
target
flash location (primary or secondary), as shown in the following
example.
OS> copy tftp flash 10.176.198.42 SPR09010aufi.bin secondary Copying SPR09010aufi.bin from 10.176.198.42 SPR09010aufi.bin 100% |*******************************|