Configuring a Custom Port Number for Connection to SmartZone

By default, ICX switches use TCP destination port 22 to connect with SmartZone. Use the manager ssh-port command to configure a different port number for connecting with SmartZone.

The following example configures an ICX switch to connect to SmartZone over SSH port 25. A warning message is displayed as shown if a session is already established. You must confirm the configuration update when prompted before the new connection is established. Check configuration status with the show manager status command.

device# configure terminal
device(config)# manager ssh-port
  DECIMAL   Enter a decimal value (Default 22)
device(config)# manager ssh-port 25

device(config)# manager ssh-port 25  <-- Warning message -->
Current session if established will be dropped to establish a new session with port 25.
Are you sure? (enter 'y' or 'n'): y  <-- You must confirm the configuration.
!
!
device(config)# exit

device# show manager status

============    MGMT Agent State Info     ===================

Config Status:Enabled Operation Status:Enabled
State:SSH CONNECTED     Prev State:SSH CONNECTING       Event:SZ_SSH_CONNECT_EVENT

SWR List                : None
DNS List                :
Active List             : 10.176.160.115
Active List IPV6        : None
DHCP Option 43          : No
DHCP Opt 43 List        : None
Backup List             : None
Backup List IPV6        : None
Merged List             : 10.176.160.115

SZ IP Used              : 10.176.160.115
Port List               : 987
Server Port Used        : 443
Query Status            : APPROVED

SSH Tunnel Status -:
Tunnel Status           : Established
SSH Port                : 25          <-- configuration confirmed
CLI IP/Port             : 127.255.255.253/22866
SNMP IP/Port            : 127.255.255.254/63989
Syslog IP/Port          : 127.0.0.1/20514
HTTP CLIENT IP/Port     : 127.0.0.1/5080
HTTP SERVER IP/Port     : 127.255.255.252/40042
Timer Status            : Not Running