RUCKUS SmartZone and Cloudpath (LT-GD) Network Segmentation Configuration Guide, 6.1.2
- Preface
- 3 Contact Information, Resources, and Conventions
- 4 About This Guide
- 5 Prerequisites
- 6 Main Configuration Steps
- 7 Configuring the Integrated System in the Cloudpath UI
- 8 Configuring the vSZ Controller to Prepare for
Network Segmentation
- 8.1 Configuring the DHCP/NAT License Assignment
- 8.2 Creating Profile-based DHCP
- 8.3 Configuring Global Settings
- 8.4 Configuring DHCP Pool Settings
- 8.5 Creating Profile-based NAT
- 8.6 Configuring NAT Global Settings
- 8.7 Configuring NAT Pool Setting
- 8.8 Creating an AP Group
- 8.9 Creating WLAN for Network Segmentation
- 8.10 Network Segmentation - SZ-DP - Data Plane Redundancy for VNIs, NAT, and DHCP
- 9 Creating Network Segmentation Profile on the vSZ Controller
- 10 Configuring a Network Segmentation Group in the Cloudpath UI
- 10.1 Viewing the Network Segmentation Landing Page
- 10.2 Creating an eDPSK Pool for a Property
- 10.3 Creating a Property for a Network Segmentation Group
- 10.4 Adding Units to a Property of a Network Segmentation Group
- 10.5 How an Access Point or Access Switch Gets Assigned to a Unit
- 10.6 Viewing or Changing Information for a Configured Unit
- 10.7 Using the Access Points Tab to View or Change an Assignment
- 10.8 Using the Edge Ports Tab to View or Remove a Switch Port Assignment
- 10.9 Property Management Information
- 10.10 Creating a Policy to Assign to eDPSK Pools (Optional)
- 10.11 Troubleshooting