Diagnostic Test and Monitoring

During system diagnostic testing, the system is completely under the control of the diagnostic software. All hardware components are verified, and results are displayed on the console. In cases where a failure is detected, results and corrective actions will be displayed. After the system diagnostic testing is complete, the system exits from the diagnostic mode and reloads the system for normal operation. System diagnostic testing runs at link speeds of 1 Gbps depending on the speed of the link being tested and the type of port. The RUCKUS device is engineered for reliability and requires no routine operational steps or maintenance. You can monitor the device by paying attention to the following information:
  • The LEDs showing the status of system components
  • A description of the operations that the device performs when you power it on
The following commands can be especially helpful in monitoring the health status of various device components. For details about these commands, refer to the RUCKUS FastIron Management Configuration Guide:
  • show chassis
  • show system
Parent topic: Monitoring the Device