Reloading the Device

After you have saved the configuration, reload the device using the reload command:

device# reload

Various tests, including Firmware Integrity Tests, Package Checksum Validation, Power-On Self Tests (POSTs), and Known Answer Tests (KATs), are run by the RUCKUS ICX device during the reload.

Firmware integrity tests are performed during bootup and image loading.

Package checksum validation checks the integrity of the packages installed in the system.

POSTs check for the consistency of the approved algorithms implemented on the device.

KATs are used to exercise various features of the approved algorithms.

All interfaces on the device are down until the tests are completed successfully.

Possible POST failure messages indicating that the device did not pass the tests successfully include the following messages:

Crypto module initialization and Known Answer Test (KAT) failed with reason:(Error
Code 0x80000000)’CKR_VENDOR_DEFINED’
FIPS: Verifying Uboot Image Checksum ...Failed
FIPS: Verifying Image Checksum ... Failed
Checksum Verification Failed For Package: AAAProcessPkg

If a failure occurs during the POST process, the device will reboot. You can access monitor mode to diagnose the issue. After all tests are completed successfully, the device reloads in Korean CC mode and Korean CC mode is successfully enabled and operational on the RUCKUS ICX device.