nat

Creates or sets the NAT server configuration settings.
Syntax
nat nat
no set [ filter ]
nat name

After the nat command is entered the following configuration syntax is available:

[ nat-log-syslog { level value } | set filter{ private-ip ip-address | private-portport-number | public-ipip-address |public-portport-number | ue-mac mac-address} | show ]

After the nat nat command is entered the following configuration syntax is available to set a pool of NAT servers:

name
Note: The show command is documented as separate command in the Show Command chapter. Refer to show nat
Command Default

NAT server configurations is enabled on entering the nat command.

Parameters
nat-log-syslog value
Specifies the Syslog level in the range 1 to 7.
set filter
Sets the filter for ?
Modes

Global configuration mode

Usage Guidelines

This command is supported on the SmartZone Data Plane controllers only.

  • set filter private-ip ip-address sets the xxx.
    Need content
  • set filter private-portport-number sets the xxx.
    Need content
  • set filter public-ipip-address sets the xxx
    need content.
  • set filter public-portport-number sets the xxx.
    Need content
  • setfilter ue-mac mac-address sets the xxx.
    need content.

Examples

The following example sets the filter for NAT server. 

device# config
device(config)#  nat 
device((config-nat)#  set filter
device(config-nat)# set filter private-port 90
Remember type "end" and type "show ue-nat-session" in first layer 
<cr>
Parent topic: Commands J through N