lwapp2scg

Updates the LWAPP2SCG configuration.
Syntax
lwapp2scg
no nat-ip-translation

After the lwapp2scg command is entered, the following configuration syntax is available:

[nat-ip-translation |pasv-port port| policy {accept | accept-all | | deny | deny-all | seconds } ]
Command Default

The LWAPP2SCG settings is enabled on executing the command.

Parameters
nat-ip-translation
Enables network address translation (NAT) in FTP passive mode.
pasv-port port
Sets the minimum and maximum port for the dynamic data transmission port range.
policy {accept | accept-all | | deny | deny-all | seconds }
Sets the ALC policy.
Modes

Global configuration mode

Usage Guidelines

This command is supported on the all SmartZone platforms except vSZ-D controller.

Parameter nat-ip-translation mode is enabled by default if the user's NAT cannot support PASV-mode FT. For parameter pasv-port PASV-mode FTP to work, the user has to set up a firewall that restricts the range of ports opened by the FTP server, thereby remaining secure, and enabling the download of AP firmware. Parameter policy the:

  • accept option allows upgrade of individual APs as required by specifying the MAC address or serial number.
  • accept-all option allows upgrade of all APs simultaneously. Make sure that there are no existing Zone Director (ZD) deployments in the same sub-net and are still in use. All the ZD APs will be affected and upgraded to the controller.
  • deny option excludes specific APs from being upgraded to controller based on the MAC address or serial number.
  • deny-all options excludes all APs from being upgraded to the controller.

Examples

The following example enables the network address translation. 

device# config
device(config)# lwapp2scg 
device(config-lwapp2scg)# nat-ip-translation
<cr>
Parent topic: Commands J through N