legacy-ssh-algorithm

Disables/Enables legacy ssh algorithm from SmartZone SSH.
Syntax
[legacy-ssh-algorithm]disable | enable
Parameters
legacy-ssh-algorithm disable
Displays the warning message. After the confirmation the command is executed successfully.
legacy-ssh-algorithm enable
Legacy ssh algorithm is enabled successfully.
Modes

Global configuration mode

Usage Guidelines

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

Examples

The following example shows how to disable/enable ssh-legacy-algorithm. 

device# config
device(config)# legacy-ssh-algorithm disable
WARNING: ICX switches/routers running firmware lower than 09.10 will not be able to connect to the SZ by disabling legacy ssh algorithm.
But connected switches with unsupported firmware continue to be registered until they are rejoined.
Do you want to continue? (or input 'no' to cancel)? [yes/no] yes
Successful operation

device(config)# legacy-ssh-algorithm enable
Successful operation
Parent topic: Commands J through N