Configuring a LAG

In this section:

1. Creating a Link Aggregation Group (LAG)
2. Configuring LAG Virtual Interface
   A LAG virtual interface allows you to enter the LAG virtual interface mode or multi-LAG virtual interface mode. To configure a LAG virtual interface, enter the following commands. All commands applicable on the physical port are available in the LAG virtual interface mode and the same applies for multi-LAG virtual interface commands as well.
3. Configuring a Layer 3 Link Aggregation Group (LAG)
   RUCKUS ICX devices running Layer 3 FastIron images support Layer 3 LAGs, which are used for routing and not switching.
4. Configuring an LACP Timeout
   In a dynamic or keep-alive LAG, a port timeout can be configured as short (3 seconds) or long (90 seconds). After you configure the port timeout, the port remains in that timeout mode regardless of whether it is up or down.
5. Specifying the LAG Threshold for a LAG
6. Enabling Ports Within a LAG
7. Disabling Ports Within a LAG
8. Removing a Port from a Currently Operational LAG
9. Monitoring LAG Virtual Interface and Individual LAG Port
10. Assigning a Name to a Port Within a LAG
11. Enabling sFlow Forwarding on a Port in a LAG
12. Setting the sFlow Sampling Rate for a LAG
13. Assigning an IP Address Within a LAG
14. Renaming an Existing LAG
    You can change the name of an existing LAG without causing any impact on the functionality of the LAG.
15. Displaying LAG Information
16. Preboot eXecution Environment Boot Support
17. User-Configured Peer Information per LACP
    RUCKUS ICX devices allow you to define the desired peers under the dynamic LAG configuration if you do not want the default first LACP trunk port to be defined as the LAG’s peer information record.