Supported Matrix and Unsupported Models
Before upgrading to this release, check if
the controller is currently managing APs, Switches or IoT devices.
APs preconfigured with the SmartZone AP firmware may be used with vSZ in their native default configuration. APs factory-configured with the ZoneFlex-AP firmware may be used with the controller when LWAPP discovery services are enabled.
Supported AP Models
This release supports the following RUCKUS AP models.
Supported AP Models
As per Wu Mit, removed AP T811CM (for 7.2.0) as it is
EOL.
As per SSP, R370 is supported in 7.2.0 and R575 is supported on
7.2.0, Patch 1.
The following lists the supported AP models in this SmartZone release when placed in an AP Zone that uses an older AP version.
Attention: The R730 AP must be removed from the AP Zone before upgrading the
AP Zone to the AP firmware version 6.1.1 or later.
Attention: For APs that are
not compatible with R7.0.0, it is essential to maintain them with AP firmware
versions of R6.1, 6.1.1, and 6.1.2. The upgrade of the Zone for APs that are not
supported in R6.1, 6.1.1, and 6.1.2 is not feasible.
Attention: AP R310 is Wave 1
and supports WPA3 – this is the one exception, the rest of the APs that support
WPA3
are 802.11ac Wave2 or 802.11ax.
Supported AP Models for AP Zones Using Older AP Versions
Unsupported AP Models
The following lists the AP models have reached end-of-life (EoL) status and, therefore, are no longer supported in this release.