Supported Matrix and Unsupported Models

Before upgrading to this release, check if the controller is currently managing APs, Switches, or IoT devices.

APs preconfigured with the SmartZone AP firmware may be used with SZ300 or vSZ in their native default configuration. APs factory-configured with the ZoneFlex-AP firmware may be used with the controller when LWAPP discovery services are enabled.

LWAPP2SCG must be disabled on the controller if Solo APs running 104.x are being moved under controller management. To disable the LWAPP2SCG service on the controller, log on to the CLI, and then go to enable > mode > config > lwapp2scg > policy deny-all. Enter Yes to save your changes.

Note: Solo APs running releases 104.x or later are capable of connecting to both Zone Director and SmartZone platforms. If an AP is running release 104.x or later and the LWAPP2SCG service is enabled on the controller, a race condition will occur.

Important: AP PoE power modes: AP features may be limited depending on power provided via PoE. Refer to AP datasheets for more information.

Supported AP Models

This release supports the following RUCKUS AP models. All RUCKUS APs support IEEE 802.11 standards.

Supported AP Models

Wi-Fi 6 (802.11ax)		Wi-Fi 6E (802.11ax)	Wi-Fi 7 (802.11be)
Indoor	Outdoor	Indoor	Indoor	Outdoor
R850	T750SE	R760	R770	T670
R750	T750	R560	R670
R650	T350C
R550	T350SE
R350	T350D
R350e
H550
H350

The following lists the supported AP models in this SmartZone release when placed in an AP Zone that uses an older AP version.

Attention: The R730 AP must be removed from the AP Zone before upgrading the AP Zone to the AP firmware version 6.1.1 or later.

Attention: For APs that are not compatible with R7.0.0, it is essential to maintain them with AP firmware versions of R6.1, 6.1.1, and 6.1.2.

Supported AP Models for AP Zones Using Older AP Versions

Wi-Fi 6 (802.11ax)	Wi-Fi 5 (802.11ac Wave 2)
Note: Supported on R6.1.0, 6.1.1, and 6.1.2.	Indoor	Outdoor
T750SE	R720	T811CM
T750	R710	T710S
T350SE	R610	T710
T350D	R510	T610S
T350C	R320	T610
R850	M510	T310S
R760 (not supported on R6.1.0)	H510	T310N
R750	H320	T310D
R730	C110	T310C
R650		T305I
R560 (not supported on R6.1.0)		T305E
R550		E510
R350
H550
H350
R310 (11ac-wave1)

Attention: AP R310 is Wave 1 and supports WPA3 – this is the one exception, the rest of the APs that support WPA3 are IEEE 802.11ac Wave 2 or IEEE 802.11ax.

Unsupported AP Models

The following lists the AP models have reached end-of-life (EoL) status and, therefore, are no longer supported in this release.

Unsupported AP Models

Unsupported AP Models
SC8800-S	SC8800-S-AC	ZF2741	ZF2741-EXT	ZF2942
ZF7025	ZF7321	ZF7321-U	ZF7341	ZF7343
ZF7343-U	ZF7351	ZF7351-U	ZF7363	ZF7363-U
ZF7441	ZF7761-CM	ZF7762	ZF7762-AC	ZF7762-S
ZF7762-S-AC	ZF7762-T	ZF7962	ZF7781CM	ZF7982
ZF7782-S	ZF7782-E	ZF7782	ZF7372-E	ZF7372
ZF7352	ZF7055	R300	R310	R700
C500	H500	R600	R500	R310
R500E	T504	T300	T300E	T301N
T301S	FZM300	FZP300

Does not support ICX configuration. ↩
FastIron 10.0.00 and later releases do not support management VLANs. ↩

RUCKUS SmartZone (ST-GA) Upgrade Guide, 7.0.0 800-73394-001 Rev H

Supported Matrix and Unsupported Models

Supported AP Models

Supported AP Models

Supported AP Models for AP Zones Using Older AP Versions

Unsupported AP Models

Unsupported AP Models