Before upgrading to this release, check if
the controller is currently managing APs, Switches or IoT devices.
APs preconfigured with the SmartZone AP firmware may be used with SZ300, SZ100, or
vSZ in their native default configuration. APs factory-configured with the ZoneFlex-AP
firmware may be used with the controller when LWAPP discovery services are enabled.
LWAPP2SCG must be disabled on the controller if
Solo APs running 104.x are being moved under controller management. To disable
the
LWAPP2SCG service on the controller, log on to the CLI, and then go to enable > mode > config > lwapp2scg > policy
deny-all. Enter Yes to save your changes.
Note: Solo APs running releases 104.x or higher are
capable of connecting to both Zone Director and SmartZone platforms. If an AP
is
running release 104.x or later and the LWAPP2SCG service is enabled on the
controller, a race condition will occur.
Important: AP PoE power modes: AP
features may be limited depending on power provided via PoE. Refer to AP datasheets
for more information.
Supported AP Models
This release supports the following RUCKUS AP
models.
Attention: AP R310 is a Wave 1 device but it supports WPA3, which is an
exception. The other APs that support WPA3 are either 802.11ac Wave 2 or
802.11ax.
Supported AP Models
11ax
11ac-Wave2
11ac-Wave1
Indoor
Outdoor
Indoor
Outdoor
Indoor
R850
T750SE
R720
T811CM
R310
R760
T750
R710
T710S
R750
T350SE
R610
T710
R650
T350D
R510
T610S
R560
T350C
R320
T610
R550
M510
T310S
R350
H510
T310N
R350e
H320
T310D
H550
C110
T310C
H350
T305I
T305E
E510
Attention: R730 needs to be deleted from the
AP Zone prior to upgrading the Zone to the AP firmware version higher or equal
to 6.1.1.
The following lists the supported AP models in
this SmartZone release when placed in an AP Zone that uses an older AP version.
Supported AP Models for AP
Zones using older AP versions
11ax
11n
11ac-Wave1
R730
ZF7982
T504
ZF7782-S
T300 or T301
ZF7782-E
R700
ZF7782
R600
ZF7781CM
R500
ZF7372-E
H500
ZF7372
C500
ZF7352
ZF7055
R300
Unsupported AP Models
The following lists the AP models have reached
end-of-life (EoL) status and, therefore, are no longer supported in this release.