Maximum Supported AP and Switch Management
SmartZone 6.1.x support dynamic (linear) AP/Switch capacity based on capacity ratio. No AP/Switch mode, only mix mode and AP/Switch support number base on total amount connect AP/Switch capacity.
High scale profile with higher switch support capacity to 5:1 from 8:1 vSZ-H L6 ~ L8 5:1 (10000 AP : 2000 switches)
Example: Calculating the Total Capacity
200 APs + 100 switches (1:5)
(200 x 1) + (100 x 5) = 700 (Total Capacity) This requirement could use L5, since the total capacity is smaller than 1,000.
400 APs + 10 switches (1:5)
(400 x 1) + (10 x 5) = 450 (Total Capacity) This requirement could use L4, since the total capacity is smaller than 500.
Note: These required resources may change from release to release. Before upgrading, always check the required resource tables for the release to which you are upgrading.
AP and Switch resource table for 1 and 2 nodes
In the following tables for three and four nodes are broken into two tables for easy readability.