Displaying Regular Mode Configuration from a PE Unit
The
show startup-config command displays the configuration a PE or provisional PE would have in regular mode
as a switch or router.
The following example displays the configuration this active PE would have if it were returned to regular mode.
[PE]ICX7450-24 Router# show startup-config *** display startup configuration used in switch/router (not PE) *** ! Startup-config data location is flash memory ! Startup configuration: ! ver 08.0.40b739T213 ! stack unit 1 module 1 icx7450-24-port-management-module module 2 icx7400-xgc-4port-40g-module module 3 icx7400-qsfp-1port-40g-module module 4 icx7400-qsfp-1port-40g-module ! ! interface management 1 ip address 10.20.226.194 255.255.255.0 ! interface ethernet 1/2/1 speed-duplex 10G-full ! interface ethernet 1/2/2 speed-duplex 10G-full ! interface ethernet 1/2/3 speed-duplex 10G-full ! interface ethernet 1/2/4 speed-duplex 10G-full ! ! End
Note: To view the configuration stored in the PE startup file, use the
show configuration command instead. The
show configuration command can also be used in regular mode to show the saved startup configuration.