OS Prompt Recovery Procedures

Note: Beginning with FastIron 09.0.10a, the no password command is no longer supported at the uboot prompt. Refer to "Password and Device Recovery" in the RUCKUS FastIron Management Configuration Guide for information on password recovery.
Note: This procedure is only supported on ICX 7150 devices.
Note: When FIPS mode is enabled, the image cannot be updated from uboot or OS prompt.

If during an upgrade procedure, the ICX device enters the OS mode and does not exit, use the copy tftp flash command at the OS prompt to re-install the image.

The following example downloads the FastIron 09.0.10a UFI from the TFTP server at the specified IP address to primary flash memory in the ICX device.

OS> copy tftp flash 192.168.10.89 SPR9010aufi.bin primary

To configure the IP address, subnet mask, and default gateway for an ICX device in OS mode, use the remote_address and remote_gateway commands, as shown in the following example.

OS> remote_address 10.176.132.159 255.255.255.128
OS> remote_gateway 10.176.132.129

To copy the FastIron image from the remote TFTP server to the ICX device at the OS prompt, use the copy tftp flash command followed by the IP address of the server, the correct image name, and the target flash location (primary or secondary), as shown in the following example.

OS> copy tftp flash 10.176.198.42 SPR09010aufi.bin secondary
Copying SPR09010aufi.bin from 10.176.198.42
SPR09010aufi.bin     100% |*******************************|

Parent topic: Software Upgrade