Changing the Cable Signal Error Scanning Interval
Proactive Monitoring of Cable Signal
Errors and Logging is enabled by default, so that every five seconds the cables
connected to
the 2.5G ports are monitored for cable signal errors. The default interval of five
seconds
can be altered. The following task changes the cable signal error scanning interval
from 5
seconds to 15 seconds.
Note: Proactive Monitoring of Cable Signal Errors and
Logging is supported for 2.5G ports only.
- Enter Global Configuration mode.
- Change the cable signal error
scanning interval from the default of 5 seconds to 15 seconds. The cable signal error scanning interval is set to 15 seconds. This value applies even after a reload.
The following example changes the cable signal error scanning interval to 15 seconds.
device# configure terminal device(config)# cable-signal-error-scan interval 15
The following example disables cable signal error scanning.
device# configure terminal device(config)# no cable-signal-error-scan