Configuring Local ND Proxy on an interface

IPv6 ND Proxy can be used to configure individual interfaces on a router.

Enter global configuration mode.
```
Router# configure terminal
```

Specify the interface to be configured in interface configuration mode.
```
Router(config)# interface ethernet 1/1/3
```

Enable IPv6 routing for the interface. The ipv6 enable command configures a router interface with an automatically computed link-local address.
```
Router(config-if-e1000-1/1/3)# ipv6 enable
```

Enable IPv6 ND Proxy using the ipv6 nd local-proxy command.
```
Router(config-if-e1000-1/1/3)# ipv6 nd local-proxy
```

Use the show ipv6 neighbor proxy command to display host entries for which the router acts as the proxy.

Router(config)# show ipv6 neighbor proxy
          
          Neighbor Entries in VRF: default-vrf
IPv6 Address                            LinkLayer-Addr State           Age        Port               vlan  IsR
4:1:1::100                              609c.9f52.241c REACH           31         e 1/1/25           1     1
4:1:1::99                               609c.9f52.f20d REACH           31         e 1/1/25           1     1

The following example configures IPv6 ND Proxy on the ethernet interface 1/1/3. The interface is manually configured with a link-local address.

Router# configure terminal
Router(config)# interface ethernet 1/1/3
Router(config-if-e1000-1/1/3)# ipv6 address FE80::240:D0FF:FE48:4672 link-local
Router(config-if-e1000-1/1/3)# ipv6 nd proxy

IPv6 Addressing

Configuring Local ND Proxy on an interface