neighbor send-community
neighbor
{
ip-address | ipv6-address | peer-group-name
}
send-community
[
both | extended | standard ]no neighbor
{
ip-address | ipv6-address |
peer-group-name
}
send-community
[
both | extended
| standard
]The device does not send community attributes.
BGP configuration mode
BGP address-family IPv6 unicast configuration mode
BGP L2VPN EVPN address family configuration mode
When this command is entered in BGP global configuration mode, it applies only to the IPv4 address family. Use this command in BGP address-family IPv6 unicast configuration mode for BGP4+ configurations. Use this command in BGP L2VPN EVPN address family configuration mode for BGP L2VPN EVPN configurations.
For the BGP L2VPN EVPN address family, this command must be configured for each BGP EVPN peer.
This command can be configured in BGP L2VPN EVPN address family configuration mode for RUCKUS ICX 7850 and ICX 7550 devices only.
The no form of the command disables the sending of the community
attribute in updates to a specified BGP neighbor.
The following example sends standard community attributes to a neighbor.
device# configure terminal device(config)# router bgp device(config-bgp-router)# neighbor 10.11.12.13 send-community standard
The following example sends standard community attributes to a neighbor for the BGP L2VPN EVPN address family.
device# configure terminal device(config)# router bgp device(config-bgp-router)# local-as 656 device(config-bgp-router)# neighbor 10.1.1.35 remote-as 656 device(config-bgp-router)# address-family l2vpn evpn device(config-bgp-l2vpn-evpn)# neighbor 10.1.1.35 activate device(config-bgp-l2vpn-evpn)# neighbor 10.1.1.35 send-community both
| Release version | Command history |
|---|---|
| 10.0.20 | This command can also be configured in BGP L2VPN EVPN address family configuration mode. |