ICX 7650, ICX 7750, or ICX 7850 units connected in a linear or ring topology. PE units are specially configured ICX 7450, ICX 7250, or ICX7150 units that are connected to the CB. The PE units can be connected to each other over a single SPX port or LAG to form a PE chain or ring. The PE chain or
are explained in more detail in the following steps. ICX7150 devices do not support Generic Routing Encapsulation (GRE) tunnels. This task is not supported for ICX7150 devices. Enter global configuration mode. device# configure terminal Enter interface configuration mode and specify an Ethernet
for ICX7150 devices. The default alarm interval for ICX7150 is 3 minutes. device(config)# optical-monitor Enabled optical monitoring and set alarm/warn interval to default(3 minutes) The default alarm interval for ICX 7550, ICX 7650, ICX 7850, and RUCKUS ICX 8200 devices is 8 minutes. device
General Considerations for Upgrade to or Downgrade from FastIron 09.0.10a or Later
08.0.95d as the intermediate version and then upgrade to FastIron 09.0.10a or later. This step is required to ensure that the FPGA version is compatible with the target release. If you are installing an ICX7150 or ICX 7450 device that contains MCU PD69220, you can prevent the POE capabilities of
LED status. The default LED status behavior also applies after the device is rebooted when all port LEDs are turned on using the led on command. The LED ON/OFF feature is supported only on the platforms where LED status mode is available. The status mode is supported on the ICX7150, ICX 7650, ICX
during operation. MCT is not supported on the ICX7150, ICX7150-ES, and ICX 8100 devices. MCT supports all the ports configured in a LAG. The maximum number of ports supported per LAG is 16 on all ICX devices that support MCT. An ICL interface cannot be configured as the CCEP in any client. BPDU guard