debug port ten-gig
Modes
Privileged EXEC mode
Global configuration mode
Usage Guidelines
Use this command in conjunction with the
debug port hw-state command.
Examples
device# debug port ten-gig Topology: Port 2/3/1 is the 10 gig port which is Up and forwarding on stack. device# debug port ten-gig device# debug port hw-state hw-state monitor hw_state change device# debug port hw-state
If port 2/3/1 is disabled, an output similar to the following is displayed.
device(config-if-e10000-2/3/1)# disable Change port 2/3/1 hw_state from PORT_READY(7) to DISABLED(0) stack: 4040 2050A970 2050AA44 2060D498 20608BF8 2060B5A4 20576A90 20576C74 2057707C 202A50A8 20491E9C 20492DC0 204906D8 2050BF48 2027FD8C 20280888 202809F0 2015FCDC 2015FF44 20160B80
If port 2/3/1 is enabled, an output similar to the following is displayed.
device(config-if-e10000-2/3/1)# enable Change port 2/3/1 hw_state from DISABLED(0) to SEEQ_INIT(1) stack: 4040 2050A970 2050AA44 2060D498 20608A34 2060B598 20576BC4 20576C74 2057707C 202A4F84 20491E9C 20492DC0 204906D8 2050BF48 2027FD8C 20280888 202809F0 2015FCDC 2015FF44 20160B80 device(config-if-e10000-2/3/1)# change port 2/3/1 hw_state from SEEQ_INIT(1) to PORT_READY(7) stack: 4040 2050A970 2050AA44 2060D498 206093D0 20609AFC 2055FA50 2050A214 200478DC 2011BBCC 20047698 2011CF7C 5008 135C8 18524