Hotspot 2.0 Release 1 Overview

Hotspot 2.0 (HS 2.0), often referred to as Wi-Fi Certified Passpoint, is the new standard for Wi-Fi public access that automates and secures the connection.

The focus of Release 1 is over-the-air security and network discovery and selection. The main enabling protocols are IEEE 802.11u, along with IEEE 802.1X, selected EAP methods, and IEEE 802.11i. Release 1 uses the WPA2-Enterprise certification program in the Wi-Fi Alliance.

The IEEE 802.11u protocol allows a mobile device to have a dialog with a Wi-Fi AP "pre-association" to determine the capabilities that the network can support. The two protocols that 802.11u uses to make this happen are the generic advertisement service (GAS) and the access network query protocol (ANQP). These protocols run on top of 802.11 and enable the Hotspot 2.0 experience.

Supported Devices:

Hotspot 2.0 Release 1 can be used with iOS devices running iOS 7 and later versions.

Main Steps:

The following is a list of the main steps you need to perform to configure Hotspot 2.0 Release 1 on your vSZ controller and your Cloudpath system:

  1. Configuring Hotspot 2.0 Release 1 Wi-Fi Operator Profile: This profile defines all the properties pertaining to an operator. You configure the domain of your Cloudpath system here. This profile will later be linked to a WLAN profile.
  2. Configuring Hotspot 2.0 Release 1 Identity Provider: This profile is where you enter network-identifying information such as Network Access Identifier (NAI) realms, and also where you can add authentication and accounting servers. This profile will also later be linked to a WLAN profile.
  3. Creating a Hotspot Portal for Hotspot 2.0 Release 1: This is where you create a captive hotspot portal to send unauthenticated users for Cloudpath enrollment.
  4. Configuring an Onboarding SSID for Hotspot 2.0 R1: This is the open, wireless LAN that you create for users to begin their onboarding process.
  5. Creating a Hotspot 2.0 WLAN Profile: This profile is where you select the previously configured Wifi Operator and Identity Provider profiles.
  6. Configuring a Secure SSID for Hotspot 2.0 R1: This is the secure network you create to which Cloudpath users will be connected upon successful authentication and enrollment.
  7. Configuring Hotspot 2.0 Release 1 on Cloudpath: This is the configuration you must perform on the Cloudpath UI to successfully link the Hotspot 2.0 Release 1 configuration you performed on the controller to a Hotspot 2.0 Release 1 Cloudpath workflow.