non-tpm-switch-cert-validate

Enables validation of non TPM (Trusted Platform Module) switch certificate.
Syntax
non-tpm-switch-cert-validate
no non-tpm-switch-cert-validate
Command Default

non TPM (Trusted Platform Module) switch certificate is enabled.

Parameters
non-tpm-switch-cert-validate
Enables the certificate validation.
Modes

Global configuration mode

Usage Guidelines

On some ICX 7250, ICX 7450, or ICX 7750 devices, self-signed certificates are used. SmartZone honors these certificates when the non-tpm-switch-cert-validate command is entered on the SmartZone console. This command is supported on all platforms except SmartZone Data Plane. The no form of the command removes the validated non TPM (Trusted Platform Module) switch certificate.

Examples

The following example enables the non TPM (Trusted Platform Module) switch certificate. 

device# config
device(config)# non-tpm-switch-cert-validate 
ap-cert-check should enable first then change ap-cert-expired-check
<cr>
History
Release version Command history
5.1 This command was added.
Parent topic: Commands J through N