mgmt-acl

Creates or updates the management interface access control list configuration.
Syntax
mgmt-acl
no enable

After the mgmt-acl command is entered the following configuration syntax is available:

[enable ]

After the enable command is entered, the following configuration syntax is available:

[ rule name ]

After the mgmt-acl rule name command is entered the following configuration syntax is available:

[description text |restriction {ipv6-subnet <ip> | range <ip> | single <ip> | subnet <ip> }]

Command Default

Management interface access settings is enabled on executing the command.

Parameters
enable
Enables the access control of the management interface.
rule name
Creates or updates the management interface ACL rule configuration.
description text
Sets the description of the LDAP service for the user.
restriction {ipv6-subnet <ip> | range <ip> | single <ip> | subnet <ip> }
Sets the restriction for the rule.
Modes

Global configuration mode

Usage Guidelines

This command is supported on the all SmartZone platforms except vSZ-D controller.

  • ipv6-subnet <ip> sets the subnet restriction along with network address and subnet mask .
  • range <ip> set the IP range restriction with start and end IP addresses.
  • single <ip> set the single IP restriction and IP address.
  • subnet <ip> sets the subnet restriction along with network address.

Examples

The following example sets the rule name for management interface ACL. 

device# config
device(config)# mgmt-acl 
device(config-mgmt-acl)# enable
device(config-mgmt-acl)# rule ruleacl
<cr>
Parent topic: Commands J through N