Commands Si - Z

In this section:

  1. sms-server
    Enters SMS configuration mode to enable SMS server configurations.
  2. smtp-server
    Enables and configures the SMTP server.
  3. snmp-notification
    Enables SNMP notifications.
  4. snmp-v2-community
    Configures the SNMPv2 community.
  5. snmp-v3-user
    Configures an SNMPv3 user.
  6. soft-gre
    Creates or updates the soft GRE tunnel profile configuration.
  7. ssh-rekey-limit
    This command is used to trigger the time or data limit for a session.
  8. stats-upload
    Updates the FTP server for uploading statistical data. If you add an FTP server to the controller, the controller will export statistics files to that FTP server, either on demand or based on a schedule.
  9. strict-wfa-compliance
    Enables strict Wi-Fi Alliance (WFA) compliance.
  10. subpackages
    Creates or updates the subscription package configuration.
  11. support-admin
    Configures support administrator configuration.
  12. syslog
    Configures the device to use the Syslog server.
  13. syslog-server
    Updates the syslog server configurations.
  14. tlsv1
    Enables Transport Layer Security version 1 (TLSv1) support.
  15. tlsversion
    Set TLS version for LBS profile.
  16. traceroute
    Displays the route that packets take to the network host.
  17. traceroute6
    Displays the route that packets take to the network IPv6 host.
  18. ttg-pdg-profile
    Creates or updates the Tunnel Terminating Gateway (TTG) and Packet Data Gateway (PDG) profile configurations.
  19. tls13-outbound
    Helps to configure whether TLS 1.3 should be used for outgoing connections.
  20. tls13-port-443
    Refers to the use of Transport Layer Security (TLS) version 1.3 over port 443.
  21. tls13-port-8443
    Refers to a specific configuration of Transport Layer Security (TLS) version 1.3 over port 8443.
  22. tls-ems-enforced
    Enables the use of EMS (Extended Master Secret) in TLS (Transport Layer Security) connections.
  23. upload ap-certificate-status
    Uploads the AP certificate to the controller.
  24. use sz
    Changes the debug tool-set category to SZ.
  25. user-agent-blacklist
    Creates and updates the user agent blacklisted configuration.
  26. user-group
    Creates and updates user group configuration.
  27. user-role
    Creates and updates the user role configuration.
  28. user-traffic-profile
    Creates and updates the user traffic profile configuration.
  29. usgv6
    Runs the US Government IPv6 (USGv6) automation tests.
  30. vlan-pooling
    Creates or updates VLAN pooling configuration.
  31. vpn
    Configures the Virtual Private Network (VPN) settings.
  32. weak-cipher-allowed
    Enables weak SSL cipher.
  33. web-authentication
    To create or update the web authentication configurations, use the following command.
  34. wechat
    Creates or updates a WeChat portal configuration.
  35. with-public-key-change
    Renews default certificate with/without updating private key.
  36. wlan
    Creates or updates WLAN configurations.
  37. wlan-group
    Creates or updates WLAN group configurations
  38. wlan-scheduler
    To create or update the WLAN scheduler configurations, use the following command.
  39. zone
    To create or update the Access Point (AP) zone configurations, use the following command.
  40. zone-template
    Creates or updates zone template configurations.