Configuring NTP on an Interface

The broadcast server or client is configured on selected interfaces.

  1. Enter global configuration mode.
    device# configure terminal
  2. Enable NTP configuration mode.
    device(config)# ntp
  3. Enter the ntp-interface command and specify the port number to configure the NTP interface.
    device(config-ntp)# ntp-interface ethernet 1/2/13
    Note: The ntp-interface command changes the command mode and will not be included in the show run command output unless a configuration exists within the interface.
  4. Exit to NTP configuration mode.
    device(config-ntp-if-e1000-1/2/13)# exit
  5. Enter the management port.
    device(config-ntp)# ntp-interface management 1
  6. Exit from the management mode.
    device(config-ntp-mgmt-1)# exit
  7. Specify the virtual port number.
    device(config-ntp)# ntp-interface ve 100
Parent topic: Configuring NTP