`register-rate-limit`

Configures the register message rate limit for Protocol Independent Multicast (PIM) and IPv6 Protocol Independent Multicast (PIMv6).

Syntax

register-rate-limit rate-limit

no register-rate-limit rate-limit

Command Default

The default register message rate limit is 1 packet per second.

Parameters

rate-limit: Specifies the maximum number of register packets sent or received per second by the router. Valid values range from 1 through 50. The default is 1.

Modes

PIM router configuration mode

IPv6 PIM router configuration mode

Usage Guidelines

This command can be used on both designated router (DR) and rendezvous point (RP) switches. The rate limit configuration applies to all (S, G) pairs.

The no form of the command restores the rate limit to 1.

Examples

The following example sets the register message rate limit to 20 packets per second.

device# configure terminal
device(config)# router pim
device(config-pim-router)# register-rate-limit 20

The following example restores the register message rate limit to the default of 1 packet per second.

device# configure terminal
device(config)# router pim
device(config-pim-router)# no register-rate-limit

The following example sets the register message rate limit to 15 packets per second for PIMv6.

device# configure terminal
device(config)# ipv6 router pim
device(config-ipv6-pim-router)# register-rate-limit 15

History

Release version	Command history
09.0.10	This command was introduced.

register-rate-limit